[plt-scheme] DrScheme configuration questions

[third attempt at mailing, sorry if more than two get through.]

1. Is there an easy way to change the default settings?  -- I have a
     (read-case-sensitive #t)
   in my language, which seems to have an effect on using it in
   DrScheme too - but this is not reflected in the language settings.

2. Is it possible to change the printer manually?  I saw that the
   three output syntaxes are pretty much hard-wired in.  (The best
   solution, IMO, is to use what MzScheme gives you in anycase, and
   have a fourth output style which should be the default for
   non-learning languages, which will use the user's `current-print'
   parameter value.  This way, a single point is needed to change the
   output.)

3. Is there an easy interface to have a language category so you get a
   tree of selections in the language select dialog rather than
   seperate lines?

-- 
          ((lambda (x) (x x)) (lambda (x) (x x)))          Eli Barzilay:
                  http://www.barzilay.org/                 Maze is Life!